Flow Reduction in Older Water Service Lines
We receive many calls from customers living in older houses with the common complaint of low pressure. After checking local
records and asking additional questions about the nature of the problem, it is often identified as low flow rather than low
pressure. This document is intended to explain the causes, responsibilities, and solutions for this type of problem.
Q. What Is the Nature of the Problem?
Q. Who Actually Owns the Service Line?
Q. What Is the Solution to the Problem?
Q. What Other Factors Should Be Considered?
--------------------------------------------------------------------------------
Q. What is the nature of the problem?
A. A common problem encountered in older homes, (those built in the 1930s and before) is a reduction of flow rate, often
misinterpreted as poor pressure. Many residences built before 1900 have 1/2" taps and 1/2" lead service lines. In later years the
common practice switched to 5/8" taps and 5/8" or 3/4" galvanized steel service lines. It was not until the 1950s and 60s that 3/4"
taps and 3/4" copper service lines became standard. The current standard is now 1" tap with a 1" copper line. The expectation of
the customer as to what constitutes a reasonable delivery rate has also changed over the past 100 years, accounting for the
increase in standard sizing. Those residences with smaller taps and services started out at a disadvantage by today's
standards.
Over time, mineral deposits accumulate on the interior surface of the service line pipe. This interior accumulation of minerals
and corrosion decreases the interior pipe diameter, and creates a rough inner surface. Both of these contribute to a reduction in
flow. The older the pipe, the worse the internal build-up problem and the lower the flow delivery. In many cases, these factors of
small initial service diameter and internal deposits combine to reduce flows to as little as 5 gallons per minute (gpm) or even
lower. Even in higher pressure areas the increased force created by the pressure in the main might not be enough to overcome
the reduction in internal service diameter. Please note that this internal build up of minerals and corrosion does not pose any
kind of health threat. In the case of lead pipe, it serves as a protective barrier between the lead and water.
Q. Who actually owns the service line?
A. A typical single family residential service line is now 1" in diameter, with a 1" tap on the water main. Street mains are typically
6", 8", or 12" in diameter. Almost all new service lines are copper. When a customer wishes to acquire a new service they
purchase a tap on the main, which is made by water company personnel. The installation of the service line, stop box (or shut off
valve), and meter pit is provided by the purchaser's licensed plumber or contractor. Actual ownership of the service line by the
customer starts at the tap on the main or at the shut off valve located at property line. All pipe, valves, and other appurtenances
from the tap or valve on into the residence are the property of the homeowner and are their responsibility. In some towns
however like Weymouth, the local town takes responsibility from the tap on the main to the shut off valve at the property line
Should a break occur on the service line between the main and the stop box, most water companies will repair the break but
may not replace the service line. Also most water companies or town water departments try to deliver water at pressures within
the range defined by their engineering Standards: 40 - 110 psi (actual customer pressure is a function of location and varies
from customer to customer). However, no guarantee of rate of flow is provided. Flow rate is typically a function of the size, length,
and condition of the service line. Estimated typical flow rate in new service lines is 12 - 16 gpm.
Q. What is the solution to the problem?
A. For most older homes with reduced flow, there are only two solutions: learn to live with the problem, or replace the service
line. The first is not very convenient and the second is very costly. In cases where the customer does not wish to spend the
money to replace the service line, changing over to some types of water-conserving fixtures (such as low-flow shower heads
and faucet aerators) may help.
Note: Low-flow toilets also can reduce demand on your pipes, but be aware that if the problem is buildup in the incoming pipes,
there is a good chance that the outgoing pipes have also been also reduced inside by corrosion buildup, and in such a case, a
low-flow toilet may not provide adequate water for flushing.
If outside irrigation is the larger concern, smaller lawn spaces, more efficient sprinkler heads, or installing a well on the property
may be effective. If the customer has the money to spend and really wishes to increase the amount of available flow, the
best solution is replacement of the service line from the tap on the main all the way into the residence. Keep in mind that
water conservation also helps to reduce the water bill.
There are two different practices in service line replacement, one far less expensive than the other. This first type is the
replacement of the service line from the residence to the meter. It is much cheaper as it does not require excavation in the street
or replacement of the meter pit and stop box. Unfortunately, this replacement does not work in all situations unless the street
side has already been previously upgraded. The best approach is complete replacement of the tap, service, and meter (if
necessary) all the way from the main in the street to the residence. A licensed, bonded plumber or contractor should do this type
of replacement. In this case, the plumber or contractor acquires the necessary permits to excavate the tap connection to the
main in the street. After exposing the main, Water company personnel can be called to the site to make a new 1" tap on the
main. Most towns charge a tap fee for this service.
Once water company personnel has replaced the tap on the main, the plumber or contractor then connects the new 1" copper
service to the new tap and extends it on to the residence with a hydraulic pulling machine or in a new trench. With a hydraulic
puller, excavations are made at both ends of the pipe and the new 1" copper service line is connected to the old service line at
one end. The machine then pulls the old service out at the other end, pulling the new service along as it goes. This process
requires less excavation than digging an entirely new trench but is not always feasible or possible.
Q. What other factors should be considered?
A. Full replacement of the service line from the main to the residence allows the user to obtain the greatest flow volume
possible from the main. It should be stressed that this may not entirely eliminate all problems. A house with an old service
typically also has old internal plumbing supplying the various fixtures inside and outside the residence. This internal plumbing
is subject to the same build-up and corrosion problems as the service line. This can create an internal bottleneck in delivering
the increased water volume, provided by a new service, to those fixtures inside the house and the hose bibs for outside
irrigation. This can mean replacement of some or all of the internal plumbing to provide the best possible delivery to each
individual point of use.
If you have additional questions regarding the need for service line or internal plumbing replacement, you may wish to contact
your local town for a listing of reputable plumbers or contractors. In all cases, it is recommended that the homeowner obtain
more than one estimate. Prices may vary dramatically from one contractor to another. It is also recommended that you ask
questions and be clear on exactly what work is to be done for what price. Questions regarding the size and date of
installation of an existing water tap as well as the actual pressure at a specific location may be directed to your local town DPW
or water department.
And of course we are always here at Zona Excavating to answer any questions you may have. Please feel free to contact us
online or give us a call.
We receive many calls from customers living in older houses with the common complaint of low pressure. After checking local
records and asking additional questions about the nature of the problem, it is often identified as low flow rather than low
pressure. This document is intended to explain the causes, responsibilities, and solutions for this type of problem.
Q. What Is the Nature of the Problem?
Q. Who Actually Owns the Service Line?
Q. What Is the Solution to the Problem?
Q. What Other Factors Should Be Considered?
--------------------------------------------------------------------------------
Q. What is the nature of the problem?
A. A common problem encountered in older homes, (those built in the 1930s and before) is a reduction of flow rate, often
misinterpreted as poor pressure. Many residences built before 1900 have 1/2" taps and 1/2" lead service lines. In later years the
common practice switched to 5/8" taps and 5/8" or 3/4" galvanized steel service lines. It was not until the 1950s and 60s that 3/4"
taps and 3/4" copper service lines became standard. The current standard is now 1" tap with a 1" copper line. The expectation of
the customer as to what constitutes a reasonable delivery rate has also changed over the past 100 years, accounting for the
increase in standard sizing. Those residences with smaller taps and services started out at a disadvantage by today's
standards.
Over time, mineral deposits accumulate on the interior surface of the service line pipe. This interior accumulation of minerals
and corrosion decreases the interior pipe diameter, and creates a rough inner surface. Both of these contribute to a reduction in
flow. The older the pipe, the worse the internal build-up problem and the lower the flow delivery. In many cases, these factors of
small initial service diameter and internal deposits combine to reduce flows to as little as 5 gallons per minute (gpm) or even
lower. Even in higher pressure areas the increased force created by the pressure in the main might not be enough to overcome
the reduction in internal service diameter. Please note that this internal build up of minerals and corrosion does not pose any
kind of health threat. In the case of lead pipe, it serves as a protective barrier between the lead and water.
Q. Who actually owns the service line?
A. A typical single family residential service line is now 1" in diameter, with a 1" tap on the water main. Street mains are typically
6", 8", or 12" in diameter. Almost all new service lines are copper. When a customer wishes to acquire a new service they
purchase a tap on the main, which is made by water company personnel. The installation of the service line, stop box (or shut off
valve), and meter pit is provided by the purchaser's licensed plumber or contractor. Actual ownership of the service line by the
customer starts at the tap on the main or at the shut off valve located at property line. All pipe, valves, and other appurtenances
from the tap or valve on into the residence are the property of the homeowner and are their responsibility. In some towns
however like Weymouth, the local town takes responsibility from the tap on the main to the shut off valve at the property line
Should a break occur on the service line between the main and the stop box, most water companies will repair the break but
may not replace the service line. Also most water companies or town water departments try to deliver water at pressures within
the range defined by their engineering Standards: 40 - 110 psi (actual customer pressure is a function of location and varies
from customer to customer). However, no guarantee of rate of flow is provided. Flow rate is typically a function of the size, length,
and condition of the service line. Estimated typical flow rate in new service lines is 12 - 16 gpm.
Q. What is the solution to the problem?
A. For most older homes with reduced flow, there are only two solutions: learn to live with the problem, or replace the service
line. The first is not very convenient and the second is very costly. In cases where the customer does not wish to spend the
money to replace the service line, changing over to some types of water-conserving fixtures (such as low-flow shower heads
and faucet aerators) may help.
Note: Low-flow toilets also can reduce demand on your pipes, but be aware that if the problem is buildup in the incoming pipes,
there is a good chance that the outgoing pipes have also been also reduced inside by corrosion buildup, and in such a case, a
low-flow toilet may not provide adequate water for flushing.
If outside irrigation is the larger concern, smaller lawn spaces, more efficient sprinkler heads, or installing a well on the property
may be effective. If the customer has the money to spend and really wishes to increase the amount of available flow, the
best solution is replacement of the service line from the tap on the main all the way into the residence. Keep in mind that
water conservation also helps to reduce the water bill.
There are two different practices in service line replacement, one far less expensive than the other. This first type is the
replacement of the service line from the residence to the meter. It is much cheaper as it does not require excavation in the street
or replacement of the meter pit and stop box. Unfortunately, this replacement does not work in all situations unless the street
side has already been previously upgraded. The best approach is complete replacement of the tap, service, and meter (if
necessary) all the way from the main in the street to the residence. A licensed, bonded plumber or contractor should do this type
of replacement. In this case, the plumber or contractor acquires the necessary permits to excavate the tap connection to the
main in the street. After exposing the main, Water company personnel can be called to the site to make a new 1" tap on the
main. Most towns charge a tap fee for this service.
Once water company personnel has replaced the tap on the main, the plumber or contractor then connects the new 1" copper
service to the new tap and extends it on to the residence with a hydraulic pulling machine or in a new trench. With a hydraulic
puller, excavations are made at both ends of the pipe and the new 1" copper service line is connected to the old service line at
one end. The machine then pulls the old service out at the other end, pulling the new service along as it goes. This process
requires less excavation than digging an entirely new trench but is not always feasible or possible.
Q. What other factors should be considered?
A. Full replacement of the service line from the main to the residence allows the user to obtain the greatest flow volume
possible from the main. It should be stressed that this may not entirely eliminate all problems. A house with an old service
typically also has old internal plumbing supplying the various fixtures inside and outside the residence. This internal plumbing
is subject to the same build-up and corrosion problems as the service line. This can create an internal bottleneck in delivering
the increased water volume, provided by a new service, to those fixtures inside the house and the hose bibs for outside
irrigation. This can mean replacement of some or all of the internal plumbing to provide the best possible delivery to each
individual point of use.
If you have additional questions regarding the need for service line or internal plumbing replacement, you may wish to contact
your local town for a listing of reputable plumbers or contractors. In all cases, it is recommended that the homeowner obtain
more than one estimate. Prices may vary dramatically from one contractor to another. It is also recommended that you ask
questions and be clear on exactly what work is to be done for what price. Questions regarding the size and date of
installation of an existing water tap as well as the actual pressure at a specific location may be directed to your local town DPW
or water department.
And of course we are always here at Zona Excavating to answer any questions you may have. Please feel free to contact us
online or give us a call.
Website designed, created and maintained by Custom Built Computers by Rick
'Search Engine Submission - www.servicewrap.net : www.zonaexcavating.com A quality website offering the best excavation and
utilities online now at affordable prices. Install Sewer Line, excavate garage foundations and more online now in Massachusetts, USA.'
utilities online now at affordable prices. Install Sewer Line, excavate garage foundations and more online now in Massachusetts, USA.'
Water Service Replacement
Excavation & Utilities
Fully Insured & Bonded
| Serving the South Shore Area |
